***THIS HUB IS LIKE THE EZRA HUB. ITCAN BE USED AS A FREECOASTER OR CASSETTE HUB. SEE VIDEOS BELOW FOR DETAILS.***
WEIGHT: 1 lb
NON DRIVE SIDE CONE NUT: CNCed 7075 T6 Alloy M14x1.0 thread
AXLE: 4130 Heat Treated Hollow Chromoly Precision CNCed axle. The axle is broached at each end to accept an 8mm hex key/allen wench to make disassembly easier. M14x1.0 threads
HUB BEARINGS: Precision sealed 6902RS2 sealed bearings. Some hubs use smaller bearings but these prove to be one of the longest lasting bearings available
HUB SHELL: Forged then CNCed from 6061T6 alloy. 36H. Features a groove to accommodate the EASTERN POP-N-LOCK HUBGUARD.
RATCHET RING: Heat treated Chromoly. Just the right hardness to never wear out
CLUTCH SPRING: Custom Precision Made spring to allow just enough tension to get the pawls moving
CLUTCH DISC: Delrin Precision CNC clutch disc (comes with three slack options)
CLUTCH DISC PILOT SPACER: CNCed 6061 Alloy
BACKSIDE DRIVER BEARING: Precision sealed 6802RS bearing. Deep grooved to provide plenty of lateral strength.
PAWLS: Precision CNCed Pawls. 3 per hub. These are used in the cassette & the freecoaster mode
RETENTION SPRINGS(used in freecoaster mode):Precision Custom Made retention springs provide just enough down force to keep the pawls out of the way in freecoaster mode.
DRIVER: 9 Tooth 4130 Heat Treated Chromoly Driver Precision CNCed
DRIVER BEARING SPACER: CNCed Bearing spacer
FRONTSIDE DRIVER BEARINGS:Precision sealed 6802RS2 bearings. Deep grooved to provide plenty of lateral strength. 2 are used under the chain to add strength.
DRIVE SIDE CONE NUT: CNCed 7075T6 Alloy
EXPANSION SPRINGS(used in cassette mode): Expansion Springs are also custom made to push the pawls up with you use the hub as a cassette